These photos show how straight-cut, upcut, and downcut bits perform in different materials. In each photo, the top row is a pocket, and the bottom row is an outline cut. For what each bit type does, see Carving Bits 101 - Bit Basics. For cut settings, see Calculating Your Cut Settings: Basic Feeds and Speeds Information.
Plastics
Acrylic
The upcut bit leaves the cleanest edges. The downcut bit packs melted chips into the cut.
HDPE
All three bits cut HDPE cleanly. The upcut bit leaves a little more fuzz on the top edge.
Expanded PVC
The upcut bit leaves clean edges. The straight-cut and downcut bits leave ragged, packed chips.
Corian
All three bits cut Corian cleanly.
Wood
Baltic birch plywood
The upcut bit tears out the top layer badly. The downcut bit leaves the cleanest top edge.
Hard maple
The upcut bit leaves some tear-out on the top edge. The downcut bit leaves the cleanest edges.
Hardwood
All three bits cut cleanly, with only small chips on the straight-cut and upcut edges.