Choosing the right bit makes a big difference to how your carve turns out. This article covers the basics: bit material, number of flutes, flute type and bit end.
Milling bits and drill bits
Use milling bits, also called end mills or carving bits, for carving. Drill bits only cut straight down, which is good for pre-drilling screw holes. Milling bits move side to side across your material and clear chips as they go, which lets you carve 2.5D and 3D designs.
Bit material
High-speed steel (HSS)
Tough, sharp and often used for aluminum. HSS bits cost less and are more forgiving, so they're good for beginners. They work in a narrower range of speeds, so check the manufacturer's feeds and speeds.
Solid carbide
The most rigid and longest-lasting, but more expensive. Most bits are solid carbide.
Carbide-tipped
A steel body with a carbide tip. They're tough and wear-resistant at a moderate price, so they're a good all-around choice.
Number of flutes
The number of flutes affects chip load, or how quickly chips are cleared from the cut.
1–2 flutes
Faster, rougher cuts with larger chips and more room to clear them. They make less heat, which keeps chips from melting back onto the bit or material. Best for soft plastics, HDPE, acrylic and aluminum.
More than 2 flutes
Slower cuts with a smoother finish, good for detail work and finishing passes. They have less room to clear chips. Best for Corian, hardwoods and other hard materials.
Flute type
Upcut
Lifts chips up and away, so plastics don't melt back together. Leaves a clean bottom edge on through-cuts but can tear out the top. Best for acrylic, HDPE, aluminum, expanded PVC and other heat-sensitive materials. Not recommended for plywood.
Downcut
Pushes chips down, leaving a clean top surface but a rougher bottom on through-cuts. Helps hold thin material (1/8" or thinner) against the wasteboard, and is good for pockets and inlays. Best for plywood and laminates. Not recommended for acrylic, HDPE or aluminum.
Straight
Pushes chips out to the side, which reduces chipping and fraying on the top surface. A good general-purpose bit. Best for bamboo, plywood and materials that splinter. Not recommended for acrylic or expanded PVC.
Compression
Upcut flutes at the bottom and downcut flutes at the top, for a clean finish on both surfaces. Best for laminates and cutting all the way through.
Bit end
Fishtail
Leaves a flat bottom with clean edges. Good for plunge cuts, thin materials, flat-bottomed pockets and plastics.
Ball nose
A rounded end that leaves curved edges and smooths out steps between passes. Good for sculpting and 3D carving. A large step over can leave ripples.
V-bit
A V-shaped tip for grooves and tapered or beveled edges, often used for signs. Smaller angles give more detail. Good for hardwoods. On plywood, use it only for test carves, since it can tear out badly.
Engraving
Very narrow V-bits, as low as 30°. They're fragile, so use them only for engraving, not for cutting through material. Good for detail in soft materials like wood. Not recommended for acrylic.
To see how different bits perform in different materials, see Bit and Material Pairings - Photos.