A Z-probe sets the Z axis of your work zero for you, so you don't have to lower the bit to your material by hand. To use one, add it to your machine settings in Easel.
Adding your Z-probe
- Open the Machine menu and click Edit your machine (1).
- Under Accessories, check Z Probe (1).
- Click Configure Z Probe (2) to test your probe.
- When you're done, click Save (3).
Testing your Z-probe
The Z Probe Configuration window walks you through checking that your probe works:
- Plug leads into carriage (1): plug the probe's leads into your machine. Easel shows Probe connected when it detects them.
- Attach clip to collet (2): attach the clip to your collet, then click Confirm.
- Touch collet with touch plate (3): touch the plate to the collet. Easel shows when it detects the connection.
Once all three steps pass, your Z-probe is ready to use.
Using your Z-probe
Once your Z-probe is added, choose Probe on the Work zero step of the carve walkthrough. See Using the Z-Probe.